D-Link xStack - Page 211

xStack® DGS-3620 Series Layer 3 Managed Stackable Gigabit Switch CLI Reference Guide
206
Parameters
<as_number 0-4294967295> - Autonomous System numbers which we use to specify a BGP
confederation. If it is set to zero, the BGP confederation number is deleted. By default, this
setting is zero. This value must be between 0 and 4294967295.
Restrictions
Only Administrator, Operator and Power-User level users can issue this command. (EI Mode Only
Command)
Example
To create a confederation, AS number is 20:
DGS-3620-28SC:admin# config bgp confederation identifier 20
Command: config bgp confederation identifier 20
Success.
DGS-3620-28SC:admin#
13-33 config bgp confederation peers
Description
The command is used to configure multiple adjacent Autonomous Systems in a confederation. The
Autonomous Systems specified in this command are visible internally to the confederation. Each
Autonomous System is fully meshed within itself or configures route reflector.
Format
config bgp confederation peers [add | delete] <aspath_list>
Parameters
peers - Specifies that a peer will be added or deleted.
add - Specifies that a peer will be added.
delete - Specifies that a peer will be deleted.
<aspath_list> - Enter the AS number for BGP peers that will belong to the confederation
here.
Restrictions
Only Administrator, Operator and Power-User level users can issue this command. (EI Mode Only
Command)
Example
To add two confederation peers, AS number are 50000 and 50001: