D-Link xStack - Page 218

xStack® DGS-3620 Series Layer 3 Managed Stackable Gigabit Switch CLI Reference Guide
213
be sent to peers in another sub AS in the same confederation and to the external peers.
no_advertise - Routes with this community will not be advertised to any peer either internal or
external.
no_export - (Optional) Routes with this community will be sent to peers in the same AS or in
other sub Autonomous Systems within a confederation, but will not be sent to an external BGP
(eBGP) peer.
community_set - (Optional) A community is 4 bytes long, including the 2 bytes’s for the
Autonomous System’s number and 2 bytes for the network number This value is configured
with two 2-byte numbers separated by a colon. The valid range of both number are from 1 to
65535. A community set can be formed by multiple communities, separated by a comma.
<community_set 80> - Enter the community set value here. This value can be up to 80
characters long.
deny - To deny the routes if rule is matched.
permit - To permit the routes if rule is matched.
expanded - Configures an expanded community list.
<list_name 16> - Name of community list to be configured.
add - Adds a rule to the community list.
delete - Deletes a rule from the community list.
<regexp_str 80> - Enter the registration expiry string value here. This value can be up to 80
characters long.
deny - To deny the routes if rule is matched.
permit - To permit the routes if rule is matched.
Restrictions
Only Administrator, Operator and Power-User level users can issue this command. (EI Mode Only
Command)
Example
This example creates a standard community list and configures permits routes from the network 10
in the Autonomous System 50000:10
DGS-3620-28SC:admin# create bgp community_list standard list1
Command: create bgp community_list standard list1
Success.
DGS-3620-28SC:admin# config bgp community_list standard list1 add
community_set 50000:10 permit
Command: config bgp community_list standard list1 add community_set 50000:10
permit
Success.
DGS-3620-28SC:admin#
13-42 delete bgp community_list
Description
This command is used to delete a BGP community list.
Format
delete bgp community_list [list_name <list_name 16> | all]