D-Link xStack - Page 233

xStack® DGS-3620 Series Layer 3 Managed Stackable Gigabit Switch CLI Reference Guide
228
Parameters
enable - To enable BGP fast external fallover flag. Default is enabled.
disable - To disable BGP fast external fallover.
Restrictions
Only Administrator, Operator and Power-User level users can issue this command. (EI Mode Only
Command)
Example
This example disables BGP fast external fallver:
DGS-3620-28SC:admin# config bgp fast_external_fallover disable
Command: config bgp fast_external_fallover disable
Success.
DGS-3620-28SC:admin#
13-56 config bgp neighbor maximum_prefix
Description
This command is used to configure the BGP neighbor maximum prefix.
Format
config bgp neighbor maximum_prefix [<ipaddr> | peer_group <peer_group_name 16>]
<value 1-12000> {<value 1-100>} {warning_only}
Parameters
<ipaddr> - Specifies the IP address of the neighbor to be configured.
peer_group - Specifies the peer group to be configured.
<peer_group_name 16> - Enter the peer group name here. This name can be up to 16
characters long.
<value 1-12000> - Maximum number of prefixes allowed from the specified neighbor. The default
is 12000.
<value 1-100> - (Optional) Integer specifying at what percentage the maximum prefix limit that
the router starts to generate a warning message. The range is from 1 to 100; the default is 75.
warning_only - (Optional) Allows the router to generate a log message when the maximum
prefix limit is exceeded, instead of terminating the peering session.
Restrictions
Only Administrator, Operator and Power-User level users can issue this command. (EI Mode Only
Command)