D-Link xStack - Page 285

xStack® DGS-3620 Series Layer 3 Managed Stackable Gigabit Switch CLI Reference Guide
280
ebgp - Configure the preference of BGP AS-external route. (EI Mode Only Parameter)
ibgp - Configure the preference of BGP AS-internal route. (EI Mode Only Parameter)
<value 1-999> - Enter the route preference value here. This value must be between 1 and 999.
Restrictions
Only Administrator, Operator and Power-User level users can issue this command.
Example
To configure the route preference for static routes to 70:
DGS-3620-28SC:admin# config route preference static 70
Command: config route preference static 70
Success.
DGS-3620-28SC:admin#
19-2 show route preference
Description
This command is used to display the route preference of each route type.
Format
show route preference {[local | static | default | rip | ospf | ospfIntra | ospfInter | ospfExt1 |
ospfExt2 | ebgp | ibgp]}
Parameters
local - (Optional) Specifies to display the preference of local route.
static - (Optional) Specifies to display the preference of static route.
default - (Optional) Specifies to display the preference of default route.
rip - (Optional) Specifies to display the preference of RIP route.
ospf - (Optional) Specifies to display the preference of all types of OSPF route.
ospfIntra - (Optional) Specifies to display the preference of OSPF intra-area route.
ospfInter - (Optional) Specifies to display the preference of OSPF inter-area route.
ospfExt1 - (Optional) Specifies to display the preference of OSPF external type-1 route.
ospfExt2 - (Optional) Specifies to display the preference of OSPF external type-2 route.
ebgp - (Optional) Specifies to display the preference of BGP AS-external route. (EI Mode Only
Parameter)
ibgp - (Optional) Specifies to display the preference of BGP AS-internal route. (EI Mode Only
Parameter)
Restrictions
None.
Example
To display the route preference for all route types: