xStack® DGS-3620 Series Layer 3 Managed Stackable Gigabit Switch CLI Reference Guide
305
state - Specifies the state of the address binding debugging option.
enable - Specifies that the address binding debugging option will be enabled.
disable - Specifies that the address binding debugging option will be disabled.
Restrictions
Only Administrator level users can issue this command.
Example
To print out all debug IMPB messages:
DGS-3620-28SC:admin# debug address_binding all state enable
Command: debug address_binding all state enable
Success.
21-2 no debug address_binding
Description
This command is used to stop the IMPB debug starting when the IMPB module receives an
ARP/IP packet or a DHCP packet.
Format
no debug address_binding
Parameters
None.
Restrictions
Only Administrator level users can issue this command.
Example
To stop IMPB debug: starting when the IMPB module receives an ARP/IP or DHCP packet:
DGS-3620-28SC:admin# no debug address_binding
Command: no debug address_binding
Success.
To Next Page
Loading...
