D-Link xStack

xStack® DGS-3620 Series Layer 3 Managed Stackable Gigabit Switch CLI Reference Guide
320
Example
To enable the OSPF debug log:
DGS-3620-28SC:admin# debug ospf log state enable
Command: debug ospf log state enable
Success.
DGS-3620-28SC:admin#
21-18 debug ospf show counter
Description
This command is used to display OSPF statistic counters.
Format
debug ospf show counter {packet | neighbor | spf}
Parameters
packet - (Optional) Specifies to display the OSPF packet counter.
neighbor - (Optional) Specifies to display the OSPF neighbor event counter.
spf - (Optional) Specifies to display the OSPF SPF event counter.
If the parameter is not specified, all OSPF counters will be displayed.
Restrictions
Only Administrator level users can issue this command.
Example
To show all OSPF statistic counters:
DGS-3620-28SC:admin# debug ospf show counter
Command: debug ospf show counter
OSPF Debug Statistic Counters
Packet Receiving:
Total : 30
Hello : 30
DD : 0
LSR : 0
LSU : 0
LSAck : 0
Drop : 0
Auth Fail : 0
Packet Sending:
Total : 59
Hello : 59
DD : 0