D-Link xStack - Page 338

xStack® DGS-3620 Series Layer 3 Managed Stackable Gigabit Switch CLI Reference Guide
333
Format
debug vrrp clear counter
Parameters
None.
Restrictions
Only Administrator level users can issue this command.
Example
To clear VRRP statistic counters:
DGS-3620-28SC:admin# debug vrrp clear counter
Command: debug vrrp clear counter
Success
DGS-3620-28SC:admin#
21-32 debug vrrp log state
Description
This command is used to enable or disable the VRRP debug log state.
Format
debug vrrp log state [enable | disable]
Parameters
state - Specifies the state of the VRRP log. The default setting is disabled.
enable - Specifies that the VRRP log state will be enabled.
disable - Specifies that the VRRP log state will be disabled.
Restrictions
Only Administrator level users can issue this command.
Example
To enable the VRRP debug log state: