D-Link xStack - Page 350

xStack® DGS-3620 Series Layer 3 Managed Stackable Gigabit Switch CLI Reference Guide
345
Example
Configure BGP to show network information:
DGS-3620-28SC:admin# debug bgp show network
Command: debug bgp show network
Network Route Map
------------- -----------
192.168.0.0/8 NULL
172.16.0.0/16 map1
Total Entries :2
DGS-3620-28SC:admin#
21-46 debug bgp show aggregate
Description
This command is used for displaying current aggregate’s configuration in BGP protocol stack.
Format
debug bgp show aggregate
Parameters
None.
Restrictions
Only Administrator-level users can issue this command. (EI Mode Only Command)
Example
Configure BGP to show aggregate information:
DGS-3620-28SC:admin# debug bgp show aggregate
Command: debug bgp show aggregate
Network Summary Only AS Set Suppress Count
------------- ------------ ------ -------------
192.168.0.0/8 YES NO 0
172.16.0.0/16 NO NO 2
Total Entries :2
DGS-3620-28SC:admin#