D-Link xStack - Page 355

xStack® DGS-3620 Series Layer 3 Managed Stackable Gigabit Switch CLI Reference Guide
350
21-52 debug bgp show redist_info
Description
This command is used for displaying current BGP redistribution information.
Format
debug bgp show redist_info
Parameters
None.
Restrictions
Only Administrator-level users can issue this command. (EI Mode Only Command)
Example
Configure BGP to show current BGP redistribution information:
DGS-3620-28SC:admin# debug bgp show redist_info
Command: debug bgp show redist_info
Last redistribution count summary:
Type Route_count_rib total_count Time(msec)
------ ---------------- --------------- ---------
OSPF 0 0 0
RIP 0 0 0
STATIC 0 0 0
LOCAL 7 0 0
Redistributed routes summary:
Network Type Next_hop
------- ---- -------------
1.10.0.1/32 LOCAL 0.0.0.0
1.10.0.2/32 LOCAL 0.0.0.0
1.10.0.3/32 LOCAL 0.0.0.0
DGS-3620-28SC:admin#
21-53 debug bgp router_map
Description
This command is used for setting route_map debugging flags to disable or enable. If this flag is
enable, route-map permit or deny in BGP module will be displayed.
Format
debug bgp router_map [enable | disable]