D-Link xStack - Page 369

xStack® DGS-3620 Series Layer 3 Managed Stackable Gigabit Switch CLI Reference Guide
364
Example
To disable RIPng debug globally:
DGS-3620-28SC:admin# debug ripng state disable
Command: debug ripng state disable
Success.
DGS-3620-28SC:admin#
21-74 debug ripng state enable
Description
This command is used to enable the RIPng debug state.
Format
debug ripng state enable
Parameters
None.
Restrictions
Only Administrator-level users can issue this command. (EI Mode Only Command)
Example
To enable RIPng debug globally:
DGS-3620-28SC:admin# debug ripng state enable
Command: debug ripng state enable
Success.
DGS-3620-28SC:admin#
21-75 debug routefilter show
Description
This command is used to display route filter information in kernel, including prefix list, access list,
and route map.
Format
debug routefilter show [prefix_list | access_list | route_map]