D-Link xStack - Page 422

xStack® DGS-3620 Series Layer 3 Managed Stackable Gigabit Switch CLI Reference Guide
417
client_mac - (Optional) Specify the MAC address of the DHCP client.
<macaddr> - Enter the MAC address.
ports - Specifies the ports.
<portlist> - Enter the range of ports to be configured.
all - Specifies to configure all ports.
delete permit server_ip - Specifies the delete permit server IP address.
<ipaddr> - Enter the IP address.
client_mac - (Optional) Specify the MAC address of the DHCP client.
<macaddr> - Enter the MAC address.
ports - Specifies the ports.
<portlist> - Enter the range of ports to be configured.
all - Specifies to configure all ports.
ports - Specifies the ports.
<portlist> - Enter the range of ports to be configured.
all - Specifies to configure all ports.
state - Specifies the port status.
enable - Enable the state.
disable - Disable the state.
illegal_server_log_suppress_duration - Specifies the illegal server log suppression duration.
1min - Specifies an illegal server log suppression duration of 1 minute.
5min - Specifies an illegal server log suppression duration of 5 minutes.
30min - Specifies an illegal server log suppression duration of 30 minutes.
Restrictions
Only Administrator, Operator and Power-User level users can issue this command.
Example
To add an entry from the DHCP server/client filter list in the switch’s database:
DGS-3620-28SC:admin#config filter dhcp_server add permit server_ip 10.1.1.1
client_mac 00-00-00-00-00-01 port 1-26
Command: config filter dhcp_server add permit server_ip 10.1.1.1 client_mac 00-
00-00-00-00-01 port 1-26
Success.
DGS-3620-28SC:admin#
To configure the filter DHCP server state:
DGS-3620-28SC:admin#config filter dhcp_server ports 1-10 state enable
Command: config filter dhcp_server ports 1-10 state enable
Success.
DGS-3620-28SC:admin#
25-2 config filter dhcp_server log
Description
This command is used to enable or disable the log for a DHCP server filter event.