D-Link xStack - Page 424

xStack® DGS-3620 Series Layer 3 Managed Stackable Gigabit Switch CLI Reference Guide
419
25-4 show filter dhcp_server
Description
This command is used to display the DHCP server/client filter list created on the switch.
Format
show filter dhcp_server
Parameters
None.
Restrictions
None.
Example
To display the DHCP server/client filter list created on the switch:
DGS-3620-28SC:admin#show filter dhcp_server
Command: show filter dhcp_server
Enabled Ports: 1,28
Trap State: Enabled
Log State: Enabled
Illegal Server Log Suppress Duration:1 minutes
Permit DHCP Server/Client Table:
Server IP Address Client MAC Address Port
----------------- ------------------ --------------------
Total Entries: 0
DGS-3620-28SC:admin#
25-5 create filter dhcpv6_server permit sip
Description
This command used to create a permit entry. The specific DHCPv6 server packets, with the source
IPv6 address, will be forwarded on the specified port(s).
Format
create filter dhcpv6_server permit sip <ipv6addr> ports [<portlist> | all]