xStack® DGS-3620 Series Layer 3 Managed Stackable Gigabit Switch CLI Reference Guide
39
Format
config 802.1x auth_parameter ports [<portlist> | all] [default | {direction [both | in] |
port_control [force_unauth | auto | force_auth] | quiet_period <sec 0-65535> | tx_period
<sec 1-65535> | supp_timeout <sec 1-65535> | server_timeout <sec 1-65535> | max_req
<value 1-10> | reauth_period <sec 1-65535> | max_users [<value 1-448> | no_limit] |
enable_reauth [enable | disable]}(1)]
Parameters
<portlist> - Enter a range of ports to be configured.
all - Specifies to configure all ports.
default - Set all parameters to the default value.
direction - (Optional) Set the direction of access control.
both - For bidirectional access control.
in - For ingress access control.
port_control - (Optional) Force a specific port to be unconditionally authorized or unauthorized
by setting the parameter of port_control to be force_authorized or force_unauthorized.
Besides, the controlled port will reflect the outcome of authentication if port_control is auto.
force_auth - The port transmits and receives normal traffic without 802.1X-based
authentication of the client.
auto - The port begins in the unauthorized state, and relays authentication messages between
the client and the authentication server.
force_unauth - The port will remain in the unauthorized state, ignoring all attempts by the
quiet_period - (Optional) The initialization value of the quietWhile timer. The default value is 60 s
and can be any value from 0 to 65535.
<sec 0-65535> - The quiet period value must be between 0 an 65535 seconds.
tx_period - (Optional) The initialization value of the txWhen timer. The default value is 30 s and
can be any value from 1 to 65535.
<sec 1-65535> - The transmit period value must be between 1 an 65535 seconds.
supp_timeout - (Optional) The initialization value of the aWhile timer when timing out the
supplicant. Its default value is 30 s and can be any value from 1 to 65535.
<sec 1-65535> - The timeout value must be between 1 an 65535 seconds.
server_timeout - (Optional) The initialization value of the aWhile timer when timing out the
authentication server. Its default value is 30 and can be any value from 1 to 65535.
<sec 1-65535> - The server timeout value must be between 1 an 65535 seconds.
max_req - (Optional) The maximum number of times that the authenitcation PAE state machine
will retransmit an EAP Request packet to the supplicant. Its default value is 2 and can be any
number from 1 to 10.
<value 1-10> - The maximum require number must be between 1 and 10.
reauth_period - (Optional) It's a non-zero number of seconds, which is used to be the re-
authentication timer. The default value is 3600.
<sec 1-65535> - The reauthentication period value must be between 1 an 65535 seconds.
max_users - (Optional) Set the maximum number of users between 1 and 448.
<value 1-448> - The maximum users value must be between 1 and 448.
no_limit - Set an unlimited number of users.
enable_reauth - (Optional) Enable or disable the re-authentication mechanism for a specific port.
enable - Enable the re-authentication mechanism for a specific port.
disable - Disable the re-authentication mechanism for a specific port.
Restrictions
Only Administrator, Operator and Power-User level users can issue this command.
To Next Page
Loading...
