D-Link xStack - Page 46

xStack® DGS-3620 Series Layer 3 Managed Stackable Gigabit Switch CLI Reference Guide
41
Format
config 802.1x init [port_based ports [<portlist> | all] | mac_based ports [<portlist> | all]
{mac_address <macaddr>}]
Parameters
port_based ports - Used to configure authentication in port-based mode.
<portlist> - Enter a range of ports to be configured.
all - Specifies to configure all ports.
mac_based ports - To configure authentication in host-based 802.1X mode.
<portlist> - Enter a range of ports to be configured.
all - Specifies to configure all ports.
mac_address - (Optional) Specify the MAC address of the host.
<macaddr> - Enter the MAC address here.
Restrictions
Only Administrator, Operator and Power-User level users can issue this command.
Example
To initialize the authentication state machine of some or all:
DGS-3620-28SC:admin# config 802.1x init port_based ports all
Command: config 802.1x init port_based ports all
Success.
DGS-3620-28SC:admin#
3-14 config 802.1x max_users
Description
This command is used to configure the 802.1X maximum number of users of the system.
Format
config 802.1x max_users [<value 1-448> | no_limit]
Parameters
<value 1-448> - Enter the maximum number of users.
no_limit - Specifies an unlimited number of users.
Restrictions
Only Administrator, Operator and Power-User level users can issue this command.
Example
To configure the 820.1X maximum numbers of the system: