xStack® DGS-3620 Series Layer 3 Managed Stackable Gigabit Switch CLI Reference Guide
460
To add the entry “dns1” with IP address 10.24.22.5 to the DNS static table:
DGS-3620-28SC:admin#config dnsr add static dns1 10.24.22.5
Command: config dnsr add static dns1 10.24.22.5
Success.
To delete the entry “dns1” with IP address 10.24.22.5 from the DNS static table:
DGS-3620-28SC:admin#config dnsr delete static dns1 10.24.22.5
Command: config dnsr delete static dns1 10.24.22.5
Success.
30-2 enable dnsr
Description
This command is used to enable DNS relay.
Format
enable dnsr {[cache | static]}
Parameters
cache - Specifies to enable the cache lookup for the DNS relay on the switch.
static - Specifies to enable the static table lookup for the DNS relay on the switch.
Restrictions
Only Administrator, Operator and Power-User level users can issue this command.
Example
To enable DNS relay:
DGS-3620-28SC:admin#enable dnsr
Command: enable dnsr
Success.
To Next Page
Loading...
