D-Link xStack - Page 474

xStack® DGS-3620 Series Layer 3 Managed Stackable Gigabit Switch CLI Reference Guide
469
Total Dynamic Entries: 0
DGS-3620-28SC:admin#
31-8 enable dns_resolver
Description
This command is used to enable the DNS Resolver state of the Switch.
Format
enable dns_resolver
Parameters
None.
Restrictions
Only Administrator, Operator and Power-User level users can issue this command.
Example
To configure the DNS Resolver state to enabled:
DGS-3620-28SC:admin# enable dns_resolver
Command: enable dns_resolver
Success.
DGS-3620-28SC:admin#
31-9 disable dns_resolver
Description
This command is used to disable the DNS Resolver state of the Switch.
Format
disable dns_resolver
Parameters
None.
Restrictions
Only Administrator, Operator and Power-User level users can issue this command.