xStack® DGS-3620 Series Layer 3 Managed Stackable Gigabit Switch CLI Reference Guide
482
vlanid - Specifies a VLAN ID list.
<vidlist> - Enter a range of VLAN IDs.
sub_ring - Specifies the sub-ring configuration.
raps_vlan - Specifies the R-APS VLAN.
<vlanid> - Enter the R-APS VLAN ID used here.
tc_propagation - Specifies to configure the state of the topology change propagation for
the sub-ring.
state - Specifies the propagation state of the topology change for the sub-ring.
enable - Enable the propagation state of the topology change for the sub-ring.
disable - Disable the propagation state of the topology change for the sub-ring.
add - Specifies the add a topology change propagation rule.
sub_ring - Specifies the sub-ring configuration information.
raps_vlan - Specifies the R-APS VLAN
<vlanid> - Enter the R-APS VLAN ID used here.
delete - Specifies the delete a topology change propagation rule.
sub_ring - Specifies the sub-ring configuration information.
raps_vlan - Specifies the R-APS VLAN.
<vlanid> - Enter the R-APS VLAN ID used here.
revertive - Specifies the revertive mode state.
enable - Specifies that the revertive mode will be enabled.
disable - Specifies that the revertive mode will be disabled.
timer - Configure the ERPS timers for a specific R-APS VLAN.
holdoff_time - Specifies the holdoff time of the R-APS function.
<millisecond 0-10000> - Enter the time between 0 and 10000. The default hold off time is
0 milliseconds.
guard_time - Specifies the guard time of the R-APS function.
<millisecond 10-2000> - Enter the time between 10 and 2000. The default guard time is
500 milliseconds.
wtr_time - Specifies the WTR time of the R-APS function.
<min 5-12> - Enter the time between 5 and 12. The default WTR time is 5 minutes.
Restrictions
Only Administrator, Operator and Power-User level users can issue this command.
Example
To set the R-APS west ring port parameter to 5:
DGS-3620-28SC:admin#config erps raps_vlan 4094 ring_port west 5
Command: config erps raps_vlan 4094 ring_port west 5
Success.
To set the R-APS east ring port parameter to 7:
DGS-3620-28SC:admin#config erps raps_vlan 4094 ring_port east 7
Command: config erps raps_vlan 4094 ring_port east 7
Success.
To set the R-APS RPL parameter:
To Next Page
Loading...
