D-Link xStack - Page 509

xStack® DGS-3620 Series Layer 3 Managed Stackable Gigabit Switch CLI Reference Guide
504
Parameters
unit - Specifies the unit ID in the stacking system. If not specified, it refers to the master unit.
<unit_id> - Enter the unit ID value here.
<drive_id> - Specifies the drive ID. If not specified, it refers to the current drive.
<pathname> - Enter the file to be deleted. If it is specified in the associated form, then it is
related to the current directory.
Restrictions
Only Administrator and Operator-level users can issue this command.
Example
To delete a file:
DGS-3620-28SC:admin#erase cfg
Command: erase cfg
Are you sure to remove the boot up Configuration from this device? (y/n)y
Success.
DGS-3620-28SC:admin#
38-8 format
Description
This command is used to format a specific drive.
Format
format {unit <unit_id>} <drive_id> {[fat16 | fat32]} {<label_name>}
Parameters
unit - Specifies the unit ID in the stacking system. If not specified, it refers to the master unit.
<unit_id> - Enter the unit ID value here.
<drive_id> - Specifies the drive ID.
fat16 - (Optional) Specifies that the drive will be formatted to support a FAT16 file system.
fat32 - (Optional) Specifies that the drive will be formatted to support a FAT32 file system.
<label_name> - (Optional) Enter the label name used for this drive here.
Restrictions
Only Administrator and Operator-level users can issue this command.
Example
To format media: