xStack® DGS-3620 Series Layer 3 Managed Stackable Gigabit Switch CLI Reference Guide
521
41-5 show igmp check_subscriber_source_network
Description
This command is used to display the status of the IGMP report/leave message source IP check.
Format
show igmp check_subscriber_source_network {ipif <ipif_name 12>}
Parameters
ipif – (Optional) Specifies the IP interface name used for this configuration.
<ipif_name 12> - Enter the IP interface name used for this configuration here. This name can
be up to 12 characters long.
If no parameter is specified, the system will display all interfaces.
Restrictions
None.
Example
To show the status of the check subscriber for the received IGMP report/leave messages on
interface “n20”:
DGS-3620-28SC:admin# show igmp check_subscriber_source_network ipif n20
Command: show igmp check_subscriber_source_network ipif n20
Interface IP Address/Netmask Check Subscriber Source Network
------------ ------------------ -------------------------------
n20 20.1.1.1/8 Disabled
Total Entries: 1
To show the status of the check subscriber for the received IGMP report/leave messages on all
interfaces:
DGS-3620-28SC:admin# show igmp check_subscriber_source_network
Command: show igmp check_subscriber_source_network
Interface IP Address/Netmask Check Subscriber Source Network
------------ ------------------ -------------------------------
System 10.90.90.90/8 Enabled
n1 1.1.1.1/8 Disabled
n11 11.1.1.1/8 Disabled
n20 20.1.1.1/8 Disabled
n100 100.3.2.2/8 Disabled
Total Entries: 5
To Next Page
Loading...
Need help?
General