D-Link xStack - Page 536

xStack® DGS-3620 Series Layer 3 Managed Stackable Gigabit Switch CLI Reference Guide
531
vlanid - Specifies the VLAN ID list.
<vlanid_list> - Enter the VLAN ID list.
all - Specifies to configure all VLANs.
state - Enable or disable IGMP snooping for the chosen VLAN.
enable - Enable IGMP snooping for the chosen VLAN.
disable - Disable IGMP snooping for the chosen VLAN.
fast_leave - Enable or disable the IGMP snooping fast leave function. If enabled, the
membership is immediately removed when the system receive the IGMP leave message.
enable - Enable the IGMP snooping fast leave function.
disable - Disable the IGMP snooping fast leave function.
proxy_reporting - Specifies the proxy reporting option.
state - Specifies the proxy reporting state.
enable - Specifies that the proxy reporting option will be enabled.
disable - Specifies that the proxy reporting option will be disabled.
source_ip - Specifies the source IP address used.
<ipaddr> - Enter the source IP addres used here.
Restrictions
Only Administrator, Operator and Power-User level users can issue this command.
Example
To configure IGMP snooping:
DGS-3620-28SC:admin#config igmp_snooping vlan_name default state enable
fast_leave enable
Command: config igmp_snooping vlan_name default state enable fast_leave enable
Success.
DGS-3620-28SC:admin#
43-2 config igmp_snooping querier
Description
This command is used to configure the IGMP snooping querier.
Format
config igmp_snooping querier [vlan_name <vlan_name 32> | vlanid <vlanid_list> | all]
{query_interval <sec 1-65535> | max_response_time <sec 1-25> | robustness_variable
<value 1-7> | last_member_query_interval <sec 1-25> | state [enable | disable] | version
<value 1-3>} (1)
Parameters
vlan_name - Specifies the name of the VLAN for which IGMP snooping querier is to be
configured.
<vlan_name 32> - Enter the VLAN name. The maximum length is 32 characters.
vlanid - Specifies the VLAN ID list.
<vlanid_list> - Enter the VLAN ID list.
all - Specifies to configure all VLANs and VLAN IDs.
query_interval - Specifies the amount of time in seconds between general query transmissions.