D-Link xStack - Page 538

xStack® DGS-3620 Series Layer 3 Managed Stackable Gigabit Switch CLI Reference Guide
533
43-3 config router_ports
Description
This command is used to designate a range of ports as being connected to multicast-enabled
routers. This will ensure that all packets with such a router as its destination will reach the
multicast-enabled router, regardless of protocol.
Format
config router_ports [<vlan_name 32> | vlanid <vlanid_list>] [add | delete] <portlist>
Parameters
<vlan_name 32> - Enter the name of the VLAN on which the router port resides.
vlanid - Specifies the VLAN ID list.
<vlanid_list> - Enter the VLAN ID list.
add - Specifies to add the router ports.
delete - Specifies to delete the router ports.
<portlist> - Enter a range of ports to be configured.
Restrictions
Only Administrator, Operator and Power-User level users can issue this command.
Example
To set up static router ports:
DGS-3620-28SC:admin#config router_ports default add 1-10
Command: config router_ports default add 1-10
Success.
DGS-3620-28SC:admin#
43-4 config router_ports_forbidden
Description
This command is used to designate a range of ports as being not connected to multicast-enabled
routers. This ensures that the forbidden router port will not propagate routing packets out.
Format
config router_ports_forbidden [<vlan_name 32> | vlanid <vlanid_list>] [add | delete]
<portlist>
Parameters
<vlan_name 32> - Enter the name of the VLAN on which the router port resides.
vlanid - Specifies the VLAN ID list.
<vlanid_list> - Enter the VLAN ID list.