D-Link xStack - Page 550

xStack® DGS-3620 Series Layer 3 Managed Stackable Gigabit Switch CLI Reference Guide
545
DGS-3620-28SC:admin#
43-18 show router_ports
Description
This command is used to display the current router ports on the switch.
Format
show router_ports [vlan <vlan_name 32> | vlanid <vlanid_list> | all] {[static | dynamic |
forbidden]}
Parameters
vlan - Specify the name of the VLAN on which the router port resides.
<vlan_name 32> - Enter the VLAN name. The maximum length is 32 characters.
vlanid - Specify the ID of the VLAN on which the router port resides.
<vlanid_list> - Enter the VLAN ID list.
all – Specifies that all the VLAN’s will be displayed.
static - (Optional) Display router ports that have been statically configured.
dynamic - (Optional) Display router ports that have been dynamically registered.
forbidden - (Optional) Display forbidden router ports that have been statically configured.
Note: If no parameter is specified, the system will display all the current router ports on
the Switch.
Restrictions
None.
Example
To display the router ports on the default VLAN:
DGS-3620-28SC:admin#show router_ports vlan default
Command: show router_ports vlan default
VLAN Name : default
Static Router Port :
Dynamic Router Port :
Router IP :
Forbidden Router Port :
Total Entries: 1
DGS-3620-28SC:admin#