To Next Page

To Previous Page

xStack® DGS-3620 Series Layer 3 Managed Stackable Gigabit Switch CLI Reference Guide

594

Parameters

<tunnel_name 12> - (Optional) Enter the IP tunnel interface name used here. This name can be

up to 12 characters long.

Restrictions

None. (EI Mode Only Command)

Example

To show an IP tunnel interface’s information (Tunnel name is “tn2”):

DGS-3620-28SC:admin# show ip_tunnel tn2

Command: show ip_tunnel tn2

Tunnel Interface : tn2

Interface Admin State : Enabled

Tunnel Mode : Manual

IPv6 Address : 2000::1/64

Tunnel Source : 1.0.0.1

Tunnel Destination : 1.0.0.2

DGS-3620-28SC:admin#

48-7 enable ip_tunnel

Description

This command is used to enable a single specified IP tunnel or all IP tunnels on the Switch.

Format

enable ip_tunnel {<tunnel_name 12>}

Parameters

<tunnel_name 12> - (Optional) Enter the IP tunnel interface name used here. This name can be

up to 12 characters long.

Restrictions

Only Administrator, Operator and Power-User level users can issue this command. (EI Mode Only

Command)

Example

To enable an IP tunnel interface (Tunnel name is “tn2”):

D-Link xStack Reference Guide

Other manuals for D-Link xStack