D-Link xStack - Page 620

xStack® DGS-3620 Series Layer 3 Managed Stackable Gigabit Switch CLI Reference Guide
615
DGS-3620-28SC:admin#
50-10 show address_binding ip_mac
Description
This command is used to display the user created database of address binding information.
Format
show address_binding ip_mac [all | [[ipaddress <ipaddr> | ipv6address <ipv6addr>]
{mac_address <macaddr>} | mac_address <macaddr>]]
Parameters
ip_mac - (Optional) Specify the database that a user creates for address binding.
all - Specifies to display all.
ipaddress - Specifies the IPv4 address.
<ipaddr> - Enter the IPv4 address here.
ipv6address - Specifies the IPv6 address.
<ipv6addr> - Enter the IPv6 address here.
mac_address - (Optional) Specify the MAC address.
<macaddr> - Enter the MAC address here.
mac_address - Specifies the MAC address.
<macaddr> - Enter the MAC address here.
Restrictions
None.
Example
To display all the IP-MAC address binding information:
DGS-3620-28SC:admin#show address_binding ip_mac all
Command: show address_binding ip_mac all
M(Mode) - D:DHCP, N:ND S:Static ACL - A:Active I:Inactive
IP Address MAC Address M ACL Ports
--------------------------------------- ----------------- -- -- --------------
-
10.1.1.1 00-11-22-33-44-55 S I 1
10.1.1.2 00-22-33-44-55-66 S A 2
2001::1 00-33-44-55-66-77 S I 3
2011::1 00-44-55-66-77-88 S I 4
Total Entries : 4
DGS-3620-28SC:admin#
To display the IMPB entry by IP address and MAC address:
DGS-3620-28SC:admin# show address_binding ip_mac ipaddress 10.1.1.1 mac_address