EasyManua.ls Logo

D-Link xStack - Page 647

D-Link xStack
1284 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
xStack® DGS-3620 Series Layer 3 Managed Stackable Gigabit Switch CLI Reference Guide
642
Parameters
<tcp_port_number 1-65535> - Enter a TCP port which the JWAC switch listens to and uses to
finish the authenticating process.
http - (Optional) Specify the JWAC run HTTP protocol on this TCP port.
https - (Optional) Specify the JWAC run HTTPS protocol on this TCP port.
Restrictions
Only Administrator, Operator and Power-User level users can issue this command.
Example
To configure the TCP port which the JWAC switch listens to:
DGS-3620-28SC:admin#config jwac switch_http_port 8888 http
Command: config jwac switch_http_port 8888 http
Success.
DGS-3620-28SC:admin#
51-17 config jwac ports
Description
This command is used to configure port state of JWAC.
Format
config jwac ports [<portlist> | all] {state [enable | disable] | max_authenticating_host <value
0-100> | aging_time [infinite | <min 1-1440>] | idle_time [infinite | <min 1-1440>] | block_time
[<sec 0-300>]}(1)
Parameters
<portlist> - Enter a port range for setting the JWAC state.
all - Specifies to configure all switch ports’ JWAC state.
state - Specifies the port state of JWAC.
enable - Specifies to enable the JWAC port state.
disable - Specifies to disable the JWAC port state.
max_authenticating_host - Specifies the maximum number of hosts that can process
authentication on each port at the same time. The default value is 100.
<value 0-100> - Enter the maximum number of authenticating hosts, between 0 and 100.
aging_time - Specifies a time period during which an authenticated host will keep in
authenticated state.
infinite - Specifies to indicate the authenticated host on the port will never ageout.
<min 1-1440> - Enter an aging time between 1 and 1440 minutes. The default value is 1440
minutes.
idle_time - If there is no traffic during idle time, the host will be moved back to unauthenticated
state.
infinite - Specifies to indicate the idle state of the authenticated host on the port will never be
checked. The default value is infinite.
<min 1-1440> - Enter an idle time between 1 and 1440 minutes.

Table of Contents

Other manuals for D-Link xStack

Related product manuals