xStack® DGS-3620 Series Layer 3 Managed Stackable Gigabit Switch CLI Reference Guide
675
56-2 delete link_aggregation group_id
Description
This command is used to delete a previously configured link aggregation group.
Format
delete link_aggregation group_id <value 1-32>
Parameters
<value 1-32> - Enter the group ID.
Restrictions
Only Administrator, Operator and Power-User level users can issue this command.
Example
To delete a link aggregation group:
DGS-3620-28SC:admin#delete link_aggregation group_id 3
Command: delete link_aggregation group_id 3
Success.
56-3 config link_aggregation group_id
Description
This command allows you to configure a link aggregation group that was created with the create
link_aggregation command above.
Format
config link_aggregation group_id <value 1-32> {master_port <port> | ports <portlist> | state
[enable | disable] | trap [enable | disable]}(1)
Parameters
<value 1-32> - Enter the group ID. The group number identifies each of the groups. The switch
allows up to 32 link aggregation groups to be configured.
master_port - Specifies which port (by port number) of the link aggregation group will be the
master port. All of the ports in a link aggregation group will share the port configuration with
the master port.
<port> - Enter the master port ID.
ports - Specifies a range of ports that will belong to the link aggregation group. The port list
should include the master port.
<portlist> - Enter a range of ports to be configured.
state - Enable or disable the specified link aggregation group. If LACP group state is enabled and
To Next Page
Loading...
