D-Link xStack - Page 719

xStack® DGS-3620 Series Layer 3 Managed Stackable Gigabit Switch CLI Reference Guide
714
DGS-3620-28SC:admin#config mac_notification interval 1 historysize 500
Command: config mac_notification interval 1 historysize 500
Success.
DGS-3620-28SC:admin#
60-4 config mac_notification ports
Description
This command is used to configure the port’s MAC address table notification status settings.
Format
config mac_notification ports [<portlist> | all] [enable | disable]
Parameters
<portlist> - Specifiy a range of ports to be configured.
all - Specifies to set all ports in the system.
enable - Specifies to enable the port’s MAC address table notification.
disable - Specifies to disable the port’s MAC address table notification.
Restrictions
Only Administrator and Operator-level users can issue this command.
Example
To enable MAC address table notification for Port 7:
DGS-3620-28SC:admin#config mac_notification ports 7 enable
Command: config mac_notification ports 7 enable
Success.
DGS-3620-28SC:admin#
60-5 show mac_notification
Description
This command is used to display the switch’s MAC address table notification global settings.
Format
show mac_notification
Parameters
None.