D-Link xStack - Page 736

xStack® DGS-3620 Series Layer 3 Managed Stackable Gigabit Switch CLI Reference Guide
731
Restrictions
Only Administrator, Operator and Power-User level users can issue this command.
Example
To disable the log state for MAC-based Access Control:
DGS-3620-28SC:admin# config mac_based_access_control log state disable
Command: config mac_based_access_control log state disable
Success.
DGS-3620-28SC:admin#
61-19 config mac_based_access_control trap state
Description
This command is used to enable or disable the sending of MAC-based Access Control traps.
Format
config mac_based_access_control trap state [enable | disable]
Parameters
state - Specifies the trap state for MAC-based Access Control.
enable - Specifies that the trap state for MAC-based Access Control will be enabled.
disable - Specifies that the trap state for MAC-based Access Control will be disabled.
Restrictions
Only Administrator, Operator and Power-User level users can issue this command.
Example
To enable the trap state for MAC-based Access Control:
DGS-3620-28SC:admin# config mac_based_access_control trap state enable
Command: config mac_based_access_control trap state enable
Success.
DGS-3620-28SC:admin#
61-20 config mac_based_access_control password_type
Description
This command is used to configure the type of RADIUS authentication password for MAC-based
Access Control.