D-Link xStack - Page 754

xStack® DGS-3620 Series Layer 3 Managed Stackable Gigabit Switch CLI Reference Guide
749
Restrictions
Only Administrator, Operator and Power-User level users can issue this command.
Example
To configure the MLD snooping packet rate limit on port 1 for 100:
DGS-3620-28SC:admin#config mld_snooping rate_limit ports 1 100
Command: config mld_snooping rate_limit ports 1 100
Success.
DGS-3620-28SC:admin#
65-3 show mld_snooping rate_limit
Description
This command is used to display the MLD snooping rate limit setting.
Format
show mld_snooping rate_limit [ports <portlist> | vlanid <vlanid_list>]
Parameters
ports - Specifies a range of ports to be displayed.
<portlist> - Enter a range of ports to be displayed.
vlanid - Specify a range of VLANs to be displayed.
<vlanid_list> - Enter the VLAN ID list.
Restrictions
None.
Example
To display the MLD snooping packet rate limit for ports 1 to 2:
DGS-3620-28SC:admin#show mld_snooping rate_limit ports 1-2
Command: show mld_snooping rate_limit ports 1-2
Port Rate Limit
-------- ------------
1 No Limit
2 No Limit
Total Entries: 2
DGS-3620-28SC:admin#