xStack® DGS-3620 Series Layer 3 Managed Stackable Gigabit Switch CLI Reference Guide
760
Query Interval : 125
Max Response Time : 10
Robustness Value : 2
Last Listener Query Interval : 1
Querier State : Disabled
Querier Role : Non-Querier
Querier IP : ::
Querier Expiry Time : 0 secs
State : Disabled
Fast Done : Disabled
Proxy Reporting : Enabled
Proxy Reporting Source IP : ::
Rate Limit : No Limitation
Version : 2
Total Entries: 1
65-16 show mld_snooping group
Description
This command is used to display the current MLD snooping group information on the switch.
Format
show mld_snooping group {[vlan <vlan_name 32> | vlanid <vlanid_list> | ports <portlist>]
{<ipv6addr>}}
Parameters
vlan - (Optional) Specify the name of the VLAN for which to view MLD snooping group
information. If VLAN and ports and IP address are not specified, the system will display all
current MLD snooping group information.
<vlan_name 32> - Specify the VLAN name. The maximum length is 32 characters.
vlanid - (Optional) Specify the ID of the VLAN for which to view MLD snooping group information.
<vlanid_list> - Enter the VLAN ID list.
ports - (Optional) Specify the list of port for which to view MLD snooping group information.
<portlist> - Enter a range of ports to be displayed.
<ipv6addr> - (Optional) Specify the group IPv6 address for which to view MLD snooping group
information.
If no parameter is specified, the system will display all MLD snooping groups on the switch.
Restrictions
None.
To Next Page
Loading...
Need help?
General