xStack® DGS-3620 Series Layer 3 Managed Stackable Gigabit Switch CLI Reference Guide
773
If no parameter is specified, the system will display all multicast VLANs on the switch.
Restrictions
None.
Example
To display all MLD snooping multicast VLANs:
DGS-3620-28SC:admin#show mld_snooping multicast_vlan
Command: show mld_snooping multicast_vlan
MLD Multicast VLAN Global State : Disabled
MLD Multicast VLAN Forward Unmatched : Disabled
VLAN Name :test
VID :100
Member(Untagged) Ports :1
Tagged Member Ports :
Source Ports :3
Untagged Source Ports :
Status :Disabled
Replace Source IP :::
Remap Priority :None
Total Entries: 1
66-13 config mld_snooping multicast_vlan forward_unmatched
Description
This command is used to configure the forwarding mode for MLD snooping multicast VLAN
unmatched packets. When the switch receives an MLD snooping packet, it will match the packet
against the multicast profile to determine which multicast VLAN to associate with. If the packet
does not match all profiles, the packet will be forwarded in the natural VLAN of the packet, or
dropped based on this setting. By default, the packet will be dropped.
Format
config mld_snooping multicast_vlan forward_unmatched [disable | enable]
Parameters
enable - The packet will be flooded on the VLAN.
disable - The packet will be dropped.
To Next Page
Loading...
Need help?
General