xStack® DGS-3620 Series Layer 3 Managed Stackable Gigabit Switch CLI Reference Guide
780
disable - Specifies that the MLD state for the specified interface will be disabled.
Restrictions
Only Administrator, Operator and Power-User level users can issue this command.
Example
To configure the MLD on the IP interface “System”:
DGS-3620-28SC:admin# config mld ipif System version 1 state enable
Command: config mld ipif System version 1 state enable
Success.
To configure the MLD version to v1 on all IP interfaces:
DGS-3620-28SC:admin# config mld all version 1
Command: config mld all version 1
Success.
To configure the MLD last listener query interval to 10 seconds on all interfaces:
DGS-3620-28SC:admin# config mld all last_listener_query_interval 10
Command: config mld all last_listener_query_interval 10
Success.
68-2 show mld
Description
This command is used to display the MLD configurations on the Switch.
Format
show mld {ipif <ipif_name 12>}
Parameters
ipif – (Optional) Specifies the IP interface name used for this configuration.
<ipif_name 12> - Enter the IP interface name used here. This name can be up to 12
If no parameter is specified, the system will display all MLD configurations.
To Next Page
Loading...
Need help?
General