xStack® DGS-3620 Series Layer 3 Managed Stackable Gigabit Switch CLI Reference Guide
782
68-3 show mld group
Description
This command is used to display the MLD group member table.
Format
show mld group {ipif <ipif_name 12> | group <ipv6addr>}
Parameters
ipif – (Optional) Specifies the IP interface name used for this configuration.
<ipif_name 12> - Enter the IP interface name used here. This name can be up to 12
group - (Optional) Specifies the IPv6 multicast group address used.
<ipv6addr> - Enter the IPv6 multicast group address used here.
If no parameter is specified, the system will display all MLD configurations.
Restrictions
None.
Example
To display all the MLD group member information on the switch, the “Expiry” uses second as the
unit:
DGS-3620-28SC:admin# show mld group
Command: show mld group
Interface Multicast Group Expiry
------------ ----------------- -----
System FF1E::100:0:0:20 260
n10 FF1E::1001:1234 255
n20 FF1E::2AC4:0:452 260
n10 FF1E::5A3D:11:23C1 260
Total Entries : 4
To display all the MLD group member information of interface “n10”, the “Expiry” uses second as
the unit:
To Next Page
Loading...
Need help?
General