D-Link xStack - Page 809

xStack® DGS-3620 Series Layer 3 Managed Stackable Gigabit Switch CLI Reference Guide
804
Parameters
enable - Enable traps for coldstart events. The default state is enabled.
disable - Disable traps for coldstart events.
Restrictions
Only Administrator and Operator-level users can issue this command.
Example
To enable traps for coldstart events:
DGS-3620-28SC:admin#config snmp coldstart_traps enable
Command: config snmp coldstart_traps enable
Success.
DGS-3620-28SC:admin#
70-20 config snmp warmstart_traps
Description
This command is used to configure the trap state for warmstart events.
Format
config snmp warmstart_traps [enable | disable]
Parameters
enable - Enable traps for warmstart events. The default state is enabled.
disable - Disable traps for warmstart events.
Restrictions
Only Administrator and Operator-level users can issue this command.
Example
To enable traps for warmstart events:
DGS-3620-28SC:admin#config snmp warmstart_traps enable
Command: config snmp warmstart_traps enable
Success.
DGS-3620-28SC:admin#