D-Link xStack - Page 815

xStack® DGS-3620 Series Layer 3 Managed Stackable Gigabit Switch CLI Reference Guide
810
Parameters
<portlist> - Enter a port or range of ports to be displayed.
Restrictions
None.
Example
To display the errors of port 1:3:
DGS-3620-28SC:admin#show error ports 1:3
Command: show error ports 1:3
Port Number : 1:3
RX Frames TX Frames
--------- ---------
CRC Error 0 Excessive Deferral 0
Undersize 0 CRC Error 0
Oversize 0 Late Collision 0
Fragment 0 Excessive Collision 0
Jabber 0 Single Collision 0
Buffer Full Drop 0 Collision 0
Symbol Error 0 STP Drop 0
ACL Drop 0 HOL Drop 0
Multicast Drop 0 COS0 HOL Drop 0
VLAN Ingress Drop 0 COS1 HOL Drop 0
Invalid IPv6 0 COS2 HOL Drop 0
STP Drop 0 COS3 HOL Drop 0
Storm and FDB Discard 0 COS4 HOL Drop 0
MTU Drop 0 COS5 HOL Drop 0
COS6 HOL Drop 0
COS7 HOL Drop 0
CTRL+C ESC q Quit SPACE n Next Page p Previous Page r Refresh
71-3 show utilization
Description
This command is used to display real-time port utilization or CPU statistics.
Format
show utilization [ports | cpu]
Parameters
ports - Specifies to display real-time port statistics.