D-Link xStack - Page 853

xStack® DGS-3620 Series Layer 3 Managed Stackable Gigabit Switch CLI Reference Guide
848
DGS-3620-28SC:admin# show ospf host_route
Command: show ospf host_route
OSPF Host Route Settings
Host Address Metric Area ID
--------------- ------ ---------------
10.48.73.21 2 10.1.1.1
10.48.74.122 1 10.1.1.1
Total Entries : 2
DGS-3620-28SC:admin#
73-14 config ospf router_id
Description
The command is used to configure the router ID for the switch. Each switch that is configured to
run OSPF must have a unique router ID.
Format
config ospf router_id <ipaddr>
Parameters
<ipaddr> - Enter the router's IP address here.
Restrictions
Only Administrator, Operator and Power-User level users can issue this command.
Example
To configure the router ID for the switch:
DGS-3620-28SC:admin# config ospf router_id 10.48.74.122
Command: config ospf router_id 10.48.74.122
Success.
DGS-3620-28SC:admin#
73-15 create ospf virtual_link
Description
This command is used to create an OSPF virtual link.