D-Link xStack - Page 871

xStack® DGS-3620 Series Layer 3 Managed Stackable Gigabit Switch CLI Reference Guide
866
Example
To display OSPFv3 areas:
DGS-3620-28SC:admin# show ospfv3 area
Command: show ospfv3 area
OSPFv3 Area Settings
Area ID Type Stub Import Summary LSA Stub Default Cost
--------------- ------ ----------------------- -----------------
0.0.0.0 Normal None None
2.2.2.2 Normal None None
Total Entries: 2
DGS-3620-28SC:admin# show ospfv3 area 0.0.0.0
Command: show ospfv3 area 0.0.0.0
Area ID: 0.0.0.0 Area Type: Normal
SPF Algorithm Runs For Area 0.0.0.0: 1 time
Number Of LSA In This Area: 2 Checksum Sum: 0x0
Number Of ABR In This Area: 0 Number Of ASBR In This Area: 0
Total Entries: 1
DGS-3620-28SC:admin#
74-9 create ospfv3 aggregation
Description
This command is used to create an OSPFv3 area aggregation.
Format
create ospfv3 aggregation <area_id> <ipv6networkaddr> advertise [enable | disable]
Parameters
<area_id> - Specifies the OSPFv3 area’s ID. It is a 32-bit number in the form of an IPv4 address
that uniquely identifies the OSPFv3 area in the OSPFv3 domain.
<ipv6networkaddr> - Specifies the IPv6 network address of the aggregation.
advertise - Specifies whether the OSPFv3 ABR will use this aggregation to aggregate the intra-
area routes or not.
enable - Specifies that the OSPFv3 ABR will use this aggregation to aggregate the intra-area
routes when it advertises these routes to another area.
disable - Specifies that the OSPFv3 ABR will not use this aggregation to aggregate the intra-
area routes when it advertises these routes to another area.