xStack® DGS-3620 Series Layer 3 Managed Stackable Gigabit Switch CLI Reference Guide
880
Format
config traffic control auto_recover_time [<min 0> | <min 1-65535>]
Parameters
<min 0> - Enter the automatic recovery time used here. This value will specifies the time to be 0
otherwise known as 'no recovery mode'.
<min 1-65535> - Enter the automatic recovery time used here. This value must be between 1
Restrictions
Only Administrator, Operator and Power-User level users can issue this command.
Example
To configure the auto recover time to 5 minutes:
DGS-3620-28SC:admin# config traffic control auto_recover_time 5
Command: config traffic control auto_recover_time 5
Success.
75-3 config traffic control log state
Description
This command is used to configure the traffic control log state. When the log state is enabled,
traffic control states are logged when a storm occurs and when a storm is cleared. If the log state
is disabled, traffic control events are not logged.
The log state is only applicable for shutdown mode. Since shutdown mode only support broadcast
and multicast storm control, doesn’t support unicast storm control. The log only generate for
broadcast and multicast storm control.
Format
config traffic control log state [enable | disable]
Parameters
state - Specifies the traffic control log state.
enable - Specifies that traffic control state will be logged when a storm occurs.
disable - Specifies that the traffic control state will be disabled.
Restrictions
Only Administrator, Operator and Power-User level users can issue this command.
To Next Page
Loading...
Need help?
General