D-Link xStack - Page 887

xStack® DGS-3620 Series Layer 3 Managed Stackable Gigabit Switch CLI Reference Guide
882
Format
show traffic control {<portlist>} {[broadcast | multicast | unicast]}
Parameters
<portlist> - (Optional) Specify a range of ports to be shown.
broadcast - (Optional) Displays the information about traffic control for broadcast packets.
multicast - (Optional) Displays the information about traffic control for multicast packets.
unicast - (Optional) Displays the information about traffic control for unicast packets.
Note: If no parameter is specified, the system will display all port packet storm control
configurations.
Restrictions
None.
Example
To display the traffic control for ports 1 to 3:
DGS-3620-28SC:admin#show traffic control 1:1-1:3
Command: show traffic control 1:1-1:3
Traffic Control Trap : [None]
Traffic Control Log : Enabled
Traffic Control Auto Recover Time: 0 Minutes
Port Broadcast/ Multicast/ Unicast/ Action Count Time Shutdown
Threshold Threshold Threshold down Interval Forever
---- --------- --------- --------- -------- -------- --------- --------
1:1 Disabled Disabled Disabled drop 0 5
131072 131072 131072
1:2 Disabled Disabled Disabled drop 0 5
131072 131072 131072
1:3 Disabled Disabled Disabled drop 0 5
131072 131072 131072
DGS-3620-28SC:admin#
To display the traffic control broadcast for ports 1 to 3:
DGS-3620-28SC:admin#show traffic control 1:1-1:3 broadcast
Command: show traffic control 1:1-1:3 broadcast
Port Status Threshold(pps) Current(pps)
---- --------------- -------------- -----------------
1:1 Link Down 131072 0
1:2 Link Down 131072 0
1:3 Link Down 131072 0