D-Link xStack - Page 89

xStack® DGS-3620 Series Layer 3 Managed Stackable Gigabit Switch CLI Reference Guide
84
DGS-3620-28SC:admin#disable aaa_server_password_encryption
Command: disable aaa_server_password_encryption
Success.
DGS-3620-28SC:admin#
4-38 config accounting
Description
This command is used to configure a user-defined or default method list of accounting methods.
Format
config accounting [default | method_list_name <string 15>] method {tacacs+ | radius |
server_group <string 15> | none}
Parameters
default - Specifies the default method list of accounting methods.
method_list_name - Specifies the user-defined method list of accounting methods.
<string 15> - Enter the user-defined method list name here. This name can be up to 15
characters long.
method - Specifies the accounting method used.
tacacs+ - Specifies to use the built-in server group 'tacacs+'.
radius - Specifies to use the built-in server group 'radius'.
server_group - Specifies the user-defined server group. If the group contains 'tacacs' or
'xtacacs' server, it will be skipped in accounting.
<string 15> - Enter the user-defined server group name here. This name can be up to 15
characters long.
none - Specifies no accounting.
Restrictions
Only Administrator level users can issue this command.
Example
To configure a user-defined method list called “shell_acct”, that specifies a sequence of the built-in
“tacacs+” server group, followed by the “radius” server group for accounting service on switch:
DGS-3620-28SC:admin#config accounting method_list_name shell_acct method
tacacs+ radius
Command: config accounting method_list_name shell_acct method tacacs+ radius
Success.
DGS-3620-28SC:admin#