D-Link xStack - Page 898

xStack® DGS-3620 Series Layer 3 Managed Stackable Gigabit Switch CLI Reference Guide
893
C-BSR Hash Mask Len : 30
C-BSR Bootstrap Period : 60
Interface IP Address Priority
------------ ------------------ -------------
System 11.52.33.3/8 -1 (Disabled)
Total Entries: 1
DGS-3620-28SC:admin#
77-8 config pim crp
Description
This command is used to set the candidate rendezvous point (RP) related parameters.
Format
config pim crp {holdtime <value 0-255> | priority <value 0-255> | wildcard_prefix_cnt [0 | 1]}
(1)
Parameters
holdtime - (Optional) This field is used to set the time Candidate RP (CRP) advertisements are
valid on the PIM-SM enabled network. If CRP advertisements are not received by the BSR
within this time frame, the CRP is removed from the list of candidates. An entry of 0 will send
out one advertisement that states to the BSR that it should be immediately removed from CRP
status on the PIM-SM network.
<value 0-255> - Enter the hold time for the RP here. This value must be between 0 and 255.
The default value is 150 seconds.
priority - (Optional) Specifies the priority used for RP election. This priority value will be included
in the router’s CRP advertisements. A lower value means a higher priority, yet, if there is a tie
for the highest priority, the router having the higher IP address will become the RP.
<value 0-255> - Enter the priority value used here. This value must be between 0 and 255.
The default value is 192.
wildcard_prefix_cnt - (Optional) Specifies the Prefix Count value of the wildcard address
(224.0.0.0/24) to be choosed. The default vaule is 0.
0 - Specifies that the wildcard prefix count value will be set to 0.
1 - Specifies that the wildcard prefix count value will be set to 1.
Restrictions
Only Administrator, Operator and Power-User level users can issue this command.
Example
To configure the candidate rendezvous point (RP) holdtime, priority and wildcard prefix count:
DGS-3620-28SC:admin# config pim crp holdtime 150 priority 192
wildcard_prefix_cnt 0
Command: config pim crp holdtime 150 priority 192 wildcard_prefix_cnt 0