D-Link xStack - Page 954

xStack® DGS-3620 Series Layer 3 Managed Stackable Gigabit Switch CLI Reference Guide
949
Format
config power_saving port [<portlist> | all] [[add | delete] time_range <range_name 32> |
clear_time_range]
Parameters
<portlist> - Enter a range of ports.
all - Specifies all ports.
add - Specifies to add a time range.
delete - Specifies to delete a time range.
time_range - Specifies the name of the time range.
<range_name32> - Enter a name for maximum 32 characters.
clear_time_range - Specifies to clear all the time range of port.
Restrictions
Only Administrator and Operator-level users can issue this command.
Example
To add a time range named “range_1” on port 1:
DGS-3620-28SC:admin#config power_saving port 1:1 add time_range range_1
Command: config power_saving port 1:1 add time_range range_1
Success.
DGS-3620-28SC:admin#
To delete a time range named “range_2” on port 1:
DGS-3620-28SC:admin#config power_saving port 1:1 delete time_range range_2
Command: config power_saving port 1:1 delete time_range range_2
Success.
DGS-3620-28SC:admin#
82-5 show power_saving
Description
This command is used to display the current state of power saving.
Format
show power_saving {length_detection | link_detection | led | port | hibernation}
Parameters
length_detection - (Optional) Display the length detection configuration of power saving.
link_detection - (Optional) Display the link detection configuration of power saving.