D-Link xStack - Page 973

xStack® DGS-3620 Series Layer 3 Managed Stackable Gigabit Switch CLI Reference Guide
968
Format
show ptp p2p_transparent ports [<portlist> | all]
Parameters
ports - Specifies the list of port used for this display.
<portlist> - Enter the list of port used for this display here.
all - Specifies that all the ports will be used for this display.
Restrictions
None.
Example
To show the configured attributes of special ports 1:1-1:4 of the p2p_transparent clock:
DGS-3620-28SC:admin# show ptp p2p_transparent ports 1:1-1:4
Command: show ptp p2p_transparent ports 1:1-1:4
The attribute configuration of the p2p_transparent ports:
PDRI : Pdelay_Request Interval
Port PDRI State
1:1 8 Enabled
1:2 16 Enabled
1:3 8 Enabled
1:4 4 Disabled
DGS-3620-28SC:admin#
83-16 show ptp foreign_master_records ports
Description
This command is used to display the current foreign master data set records of the boundary
clock’s special ports.
Format
show ptp foreign_master_records ports [<portlist> | all]
Parameters
ports - Specifies the list of port used for this display.
<portlist> - Enter the list of port used for this display here.
all - Specifies that all the ports will be used for this display.
Restrictions
None.