xStack® DGS-3620 Series Layer 3 Managed Stackable Gigabit Switch CLI Reference Guide
973
84-4 show dot1v_protocol_group
Description
This command is used to display the protocols defined in protocol groups.
Format
show dot1v_protocol_group {[group_id <int 1-16> | group_name <name 32>]}
Parameters
group_id - (Optional) Specify the group ID to be displayed.
<int 1-16> - Enter the group ID to be displayed.
group_name - (Optional) Specify the name of the protocol group.
<name 32> - Enter the name of the protocol group. The maximum length is 32 characters.
Note: If no parameter is specified, all configured protocol groups will be displayed
Restrictions
None.
Example
To display protocol group ID 4:
DGS-3620-28SC:admin# show dot1v_protocol_group group_id 4
Command: show dot1v_protocol_group group_id 4
Protocol Protocol Frame Type Protocol
Group ID Group Name Value
--------- --------------- ------------ ------------
4 General Group EthernetII 86dd
Total Entries: 1
84-5 config port dot1v ports
Description
This command is used to assign the VLAN for untagged packets ingress from the portlist based on
the protocol group configured. This assignment can be removed by using the delete
protocol_group option.
When priority is not specified in the command, the port default prority will be the priority for those
untagged packets classified by the protocol VLAN.
To Next Page
Loading...
Need help?
General