AV7000 LINEAR CAMERA REFERENCE MANUAL
4. Confirm that the application’s correct MAX conveyor speed (Formula: Max conveyor speed
x 1.05) is in the Conveyor Speed field. This is used by the AV7000 to set the image
exposure time.
5. Place the CH-3 Autofocus Test Chart at the FARTHEST distance from the AV7000 (far
working distance).
6. Adjust the target position until the center pattern is represented by only a single line.
Figure 117: Focus Target Position
7. Zoom into the focused area with the mouse by left clicking and holding the curser on
the left side of the image and then dragging the curser to the right. Release the mouse
button past the second focused area. This minimizes the amount of data the AV7000
has to process during this calibration step.
To Next Page
Loading...
Need help?
General
