Datalogic AV7000 Reference Manual

AV7000 LINEAR CAMERA REFERENCE MANUAL
26
2
2.4.7 Mounting Rails
The Camera/Illuminator and Deflection Mirror are mounted to mounting structure rails, as
shown below. Typically, the rising brackets are mounted to the rails, but in some cases it
may be necessary to mount the camera and deflection mirror between the mounting rails.
Figure 23: Mounting Rail positioning, above rail with rising bracket (typical) and between rails
For Rail configurations, the rails must be mounted so that the distance between the extrusion
profiles (Bosch or 80/20) matches the illuminator model being used.
For Top Camera positions (both Direct and Indirect), the distance between the profiles
measured from the internal sides is given in the following table depending on the illuminator
model:
Illuminator
Body
Width
x Distance Between Rail
Slots with Rising Brackets
x Distance Between Rails
without Rising Brackets
Short
845 mm
945 mm
37.2 in
885 mm
34.8 in
Medium
1150 mm
1250 mm
49.2 in
1190 mm
46.8 in
Long
1480 mm
1580 mm
62.2 in
1520 mm
59.8 in
For Side Camera positions (either Direct or Indirect), the distance between the profiles
measured from the internal sides is given in the following table depending on the illuminator
model:
Illuminator
Body Width
x Distance Between Rail
Slots with Rising Brackets
x Distance Between Rails
without Rising Brackets
Short
845 mm
955 mm
37.6 in
895 mm
35.24 in
Medium
1150 mm
1260 mm
49.6 in
1200 mm
47.24 in
Long
1480 mm
1590 mm
62.6 in
1530 mm
60.24 in

Datalogic AV7000 Specifications

General

Brand	Datalogic
Model	AV7000
Category	Digital Camera
Language	English