AV7000 LINEAR CAMERA REFERENCE MANUAL
3 ELECTRICAL INSTALLATION
3.1 PREPARING FOR ELECTRICAL INSTALLATION
Before mounting any components, please do the following:
ï‚· Read all instructions before beginning your installation.
ï‚· Observe all electrical safety requirements discussed in the Introduction to this manual.
 Define and confirm the accuracy of your application’s requirements.
ï‚· Review all installation-specific drawings.
ï‚· Review and plan the power requirements for your application.
ï‚· Review and plan the communications requirements for your application.
IMPORTANT: The content of this manual may be superseded by
any customer-specific documentation provided by Datalogic. Before
proceeding with any installation procedures, be sure to review ALL
documentation, especially content that contains details specific to
your installation.
NOTE: Everything should be MECHANICALLY INSTALLED before
performing any ELECTRICAL INSTALLATION. See Chapter 2 for
mechanical installation details.
Most AV7000 applications are shipped with the CBX connection box
and all the necessary cabling required to electrically install the
system. If your system requires custom-length cables or other
special wiring, documentation specific to these requirements has
been provided in your shipment. This special documentation
supersedes any contradictory content in this manual.
NOTE: To reduce the possibility of damage to the unit, check all
cabling between the AV7000 camera and other devices for accuracy.
WARNING: Electrical Installation must be performed by Qualified
Service Technicians Only! Procedures may involve exposure to high-
voltage. A trained and authorized technician must perform these
procedures. Do not attempt to perform any electrical installation
procedures unless you are a trained technician.
IMPORTANT: The AV7000 contain electronics that may be affected by
electrostatic discharge (ESD). To prevent personal injury or damage to
the unit, please follow the safety precautions and warnings found in the
References section at the beginning of this manual. Failure to follow
these precautions may void your warranty.