Delta DVP-15MC Series User Manual

Chapter 11 Motion Control Instructions
11-255
11
Note:
The location with an underline is the value of the parameter to be set.
When one G code need be input in the CNC program in the CANopen Builder, N_ must be put to the left of
G code. N_ means the row number of the G code in the NC program.
Every row has only one G code input.
The input format of G codes in the CANopen Builder software is as follows.
N0 G0 X100 Y100

Delta DVP-15MC Series Specifications

General

Brand	Delta
Model	DVP-15MC Series
Category	Controller
Language	English