ICS-3000 Ion Chromatography System
28 Doc. 065031-04 1/08
The analog pressure output defaults to the pump 1 (bottom pump) output signal.
To redirect the output to pump 2 (the top pump), follow these steps:
1. In Chromeleon or Chromeleon Xpress, select Command on the Control
menu or press the F8 key.
2. In the Commands dialog box, select the pump name.
3. Select the AnalogOut command.
4. Select PumpTop in the AnalogOut drop-down box and click Execute.
USB Connections
• One USB receptacle (“B” type connector) allows a connection from the PC on
which Chromeleon or Chromeleon Xpress software is installed.
• Three USB (Universal Serial Bus) ports (“A” type connectors) are provided
for connections to other ICS-3000 modules.
One 1.8-m (6-ft) USB cable (P/N 960777) is provided in the ship kit (DP Ship Kit,
P/N 062463; SP Ship Kit, P/N 063342).
Waste Lines
• One waste line is connected to the secondary pump head.
• One waste line exits the drip tray and is routed to the rear panel.
Place the free ends of the waste lines into one waste container. To maintain a
positive siphon, position the waste container below the level of the pump.
NOTE To ensure proper drainage, the waste lines must remain
above the liquid level in the waste container.
To Next Page
Loading...
