Chapter 20
| ERPS Commands
– 546 –
erps domain This command creates an ERPS ring and enters ERPS configuration mode for the
specified domain. Use the no form to delete a ring.
Syntax
erps domain ring-name [id ring-id]
no erps domain ring-name
ring-name - Name of a specific ERPS ring. (Range: 1-12 characters)
ring-id - ERPS ring identifier used in R-APS messages. (Range: 1-255)
Default Setting
None
Command Mode
Global Configuration
Command Usage
â—† Service Instances within each ring are based on a unique maintenance
association for the specific users, distinguished by the ring name, maintenance
level, maintenance association’s name, and assigned VLAN. Up to 6 ERPS rings
can be configured on the switch.
â—† R-APS information is carried in an R-APS PDUs. The last octet of the MAC
address is designated as the Ring ID (01-19-A7-00-00-[Ring ID]). If use of the
default MAC address is disabled with the no raps-def-mac command, then the
Ring ID configured by the erps domain command will be used in R-APS PDUs.
Example
Console(config)#erps domain r&d id 1
Console(config-erps)#
control-vlan This command specifies a dedicated VLAN used for sending and receiving ERPS
protocol messages. Use the no form to remove the Control VLAN.
Syntax
[no] control-vlan vlan-id
vlan-id - VLAN ID (Range: 1-4094)
Default Setting
None
Command Mode
ERPS Configuration
To Next Page
Loading...
Need help?
General